![]() the RF source to the end node can be increased with 1) Voltage the help gain: of two Voltage intermediate gain at the nodes end directly node is the between ratio of the the RF difference source and in the the end voltage node. The IN DENSE performances NETWORKS in these cases of two In paths this section, along with we that illustrate of three how paths the have efficiency been of compared energy with transfer the from DET. The 3-path energy routing can be identified as left-right- direct scenario, where the left and right paths are 2-hop and the direct path IV. 1(b), only the left intermediate node is present, whereas in the right-direct scenario, only the right intermediate node is present in the set- up. In the left-direct scenario, out of 2 intermediate nodes in Fig. We considered two variations of 2-path energy routing, namely, left-direct and right-direct scenarios. It should be noted that the intermediate nodes (left and right) are not part of the set-up for the DET case. Moreover, here we are using 1 dBi omnidirectional antenna at the end node so that it can receive power efficiently from all directions, which is required in this case because the distance between the end node and the intermediate node has been kept larger to avoid any blocking. For more details related to mote programming, the reader may refer to our previous work. For efficient RFET, the Mica2 mote has been programmed to transmit packets continuously one after the other during the ON state. It should be noted that the energy router can harvest and also transmit energy at the same time as it has two antennae one for harvesting energy and the other for transmission.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |